Thanks very much for thinking about this!
When the green light is on and GENERAL_STATE is 70, ethtool shows:
But once I try and fail to connect and the green light goes off and GENERAL_STATE becomes 20, ethtool instead shows:
Code:
# lspci -nn | fgrep -i eth00:1f.6 Ethernet controller [0200]: Intel Corporation Ethernet Connection I219-LM [8086:156f] (rev 21)Code:
# ethtool enp0s31f6Settings for enp0s31f6:Supported ports: [ TP ]Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: NoSupports auto-negotiation: YesSupported FEC modes: Not reportedAdvertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: NoAdvertised auto-negotiation: YesAdvertised FEC modes: Not reportedSpeed: 10Mb/sDuplex: FullPort: Twisted PairPHYAD: 1Transceiver: internalAuto-negotiation: onMDI-X: on (auto)Supports Wake-on: pumbgWake-on: gCurrent message level: 0x00000007 (7) drv probe linkLink detected: yesCode:
# ethtool enp0s31f6Settings for enp0s31f6:Supported ports: [ TP ]Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: NoSupports auto-negotiation: YesSupported FEC modes: Not reportedAdvertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: NoAdvertised auto-negotiation: YesAdvertised FEC modes: Not reportedSpeed: Unknown!Duplex: Unknown! (255)Port: Twisted PairPHYAD: 2Transceiver: internalAuto-negotiation: onMDI-X: Unknown (auto)Supports Wake-on: pumbgWake-on: gCurrent message level: 0x00000007 (7) drv probe linkLink detected: noStatistics: Posted by MassPikeMike — 2024-08-17 00:36
